Table of Contents
Advertisement
12 July '86
5.
Front Wire Replacement
a.
Remove the old wire.
b.
Insert the red end bead [A] of the new wire into the slot of the
drive pulley and wrap the wire twice around the drive pulley
(clockwise).
c.
String the wire over all the pulleys, except the idle pulley [B],
wrapping the wire around the friction roller drive pulley 5 times
clockwise as shown.
d.
Wrap the other end of the wire around the drive pulley 2.5 times
clockwise and insert the bead into the drive pulley slot.
e.
Insert the two support beads into the lift rod slots.
f.
Now, string the wire over the tension pulley.
6.
Reinstall the friction roller drive gear assembly and the wire tensioning
spring.
7.
Confirm that the wires are not crossed and that the bottom plate can
move down by itself after being lifted manually.
8.
Reinstall the tray motor.
9.
Push up the wire tension stopper and tighten it while holding the wire
tension (1 screw each, front and rear).
10.
Reassemble the paper tray unit.
11.
Reinstall the paper tray unit (2 screws).
12.
Check the up and down operation of the tray.
7-14
Advertisement
Chapters
Table of Contents
