Punch Edge Sensor Adjustment - Oce CS240 Operation Manual

Utility mode
9
Check the print result.
– Check that the angle of the punched holes was adjusted.
– If more adjustment is necessary, repeat steps 6 and 7.

Punch edge sensor adjustment

The sensors for detecting the paper edges when printing with a Punch setting can be adjusted.
Note
[Punch Edge Sensor Adjustment] appears only if optional finisher FS-517 or FS-608 is installed.
For details on the Punch settings, refer to "Punching holes in copies ("Punch" settings)" on page 4-69.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to "Displaying the administrator
settings screen" on page 13-35.
2
Touch [1 System Settings].
The System Settings screen appears.
3
Touch [7 Expert Adjustment].
The Expert Adjustment screen appears.
4
Touch [3 Finisher Adjustment].
The Finisher Adjustment screen appears.
5
Touch [8 Punch Edge Sensor Adjustment].
The Punch Size Detect Sensor screen appears.
CS240/CS231
13
13-57