Electrostatic Charger Wire; Print Head - Oce CS240 Operation Manual

Care of the machine

Electrostatic charger wire

If the electrostatic charger wire is dirty, streaks will appear though the printed images. If this occurs, follow
the procedure described below to clean the electrostatic charger wire.
1
Open the machine's lower front door.
2
Slowly pull out the charger-cleaning tool as far as possible.
Next, slowly push in the charger-cleaning tool as far as
possible.
Repeat the above operations three times.
3
Securely insert the charger-cleaning tool, and then close the front door.

Print head

If the print head becomes dirty, decreased print quality may result. If this occurs, clean the print head
according to the following procedure.
1
Pull out tray 1.
2
Remove the cleaning tool from tray 1.
CS240/CS231
11
11-5