Draining And Filling The Oil In The Looper Drive Housing - DURKOPP ADLER 610 Service Instructions Manual

Setting the looper

9.1.1 Draining and filling the oil in the looper drive housing

Fig. 27: Draining and filling the oil in the looper drive housing
Draining the oil
1. Tilt the machine backwards ( Section 3.5.1, pg. 11).
2. Loosen the oil drain screw (2).
3. Place an appropriate collection tray in the oil pan (3).
4. Carefully tilt the machine backward and allow the oil to drain out com-
Topping up the oil
1. Tilt the machine backwards ( Section 3.5.1, pg. 11).
2. Top up the looper drive housing (1) with the oil, DA 10 up to the upper
3. Screw in the oil drain screw (2).
Service Instructions 610/630 - 00.0 - 10/2014
ATTENTION
Risk of environmental damage from lubricant
Lubricant is a pollutant and must not enter the sewage system
or the soil.
Collect waste lubricant carefully and dispose of it and greasy
machine parts in accordance with the applicable statutory reg-
ulations.
Please observe all safety and environmental protection in-
structions issued by the lubricant manufacturer.
②
①
(1) - Looper drive housing
(2) - Oil drain screw
pletely.
mark (4) on the sight glass.
④
③
(3) - Oil pan
(4) - Mark
35