Setting steps
1. Secure the bottom feed gauge (0178 800010) with two M5x16 screws
2. Turn both switching flags (8) of both upper stepper motors (4,6) such
The edge of the switching flag lies on the roller.
Fig. 56: Switching flags
(7) - Roller
3. Loosen the clamping screws (3) for both guides.
4. Insert 6-pin (2) into the left hole of one guide and turn the guides such
5. Insert 6-pin into the right hole of the other guide and turn the guides
6. Secure the clamping screws (3) for both guides.
7. Remove the bottom feed gauge.
62
or knurled screw (9210 013397).
that the rollers (7) are at the largest diameter of the switching flags.
that the 6-pin (2) comes to rest against the gauge (1).
such that the 6-pin (2) comes to rest against the gauge (1).
Differential top and bottom feed
⑦
⑧
(8) - Switching flag
Service Instructions 610/630 - 00.0 - 10/2014