Table of Contents
Advertisement
12.5 Basic setting of top feed guides
Cover
• Remove the arm cover ( Section 3.5.3, pg. 12)
• Tilt the machine ( Section 3.5.1, pg. 11)
Fig. 64: Aligning the guide
(1) - Clamping screw
(2) - 5-pin
Setting steps
1. Turn the switching flag of the center stepper motor such that the sensing
The edge of the switching flag lies on the roller.
Fig. 65: Setting of top feed guide
2. Loosen the clamping screws (1).
3. Align the guide with a 5-pin (1) to the edge.
4. Secure the clamping screws (3) for both guides.
68
WARNING
Risk of injury
Risk of crushing from moving parts
Switch off the sewing machine before setting the guide.
①
②
③
roller is at the smallest diameter of the switching flag.
(3) - Edge
Service Instructions 610/630 - 00.0 - 10/2014
Foot top feed
Advertisement
Table of Contents
