Table of Contents
Advertisement
3) Thread clamping plate
Fig. 69: Thread clamping plate
The thread clamping plate (1) should hold the cut thread ends gently to en-
sure a smooth start to sewing.
Important
If the clamping plate is too tight this can case ruffing at the start of sewing.
4) Install the thread cutter
Fig. 70: Installing the thread cutter
1. Loosen screw (3) and remove the movable blade (4).
2. Position the thread cutter such that the blade holder (1) fits over the ball
3. Tighten the screws (5).
4. Insert blade (4) and secure with screw (3).
72
①
(1) - Thread clamping plate
①
②
(1) - Blade mounting
(2) - Ball lever
(3) - Screw
lever (2).
Setting the thread take-up disk
⑤
④
③
(4) - Blade
(5) - Screw
Service Instructions 610/630 - 00.0 - 10/2014
Advertisement
Table of Contents
