Table of Contents
Advertisement
Fig. 58: Stroke height of the top feed
(1) - Screw
(3) - Bearing block
(5) - Clamping hub
Setting steps
1. Loosen the screw (1).
2. Move the bearing block (3) and set the dimension to 71.5 mm.
3. Tighten the screw (1).
4. Release the rocker lever (4) (swivel to the left).
5. Loosen the screw (6) of the clamping hub (5).
6. Turn the lifting shaft (7).
Fig. 59: Top feed foot and throat plate
(8) - Throat plate
Important:
Set only as much lift as is required. The higher the stroke, the shorter the
movement of the top feed on the feed.
7. Tighten the screw (6).
64
①
The top feed foot (9) should have a maximum stroke of 2 mm to the
throat plate (8).
Turn the lifting shaft until the top feed has achieved the required stroke.
⑨
⑧
⑤
⑦
③
(6) - Screw
(7) - Lifting shaft
2 mm
(9) - Top feed foot
Service Instructions 610/630 - 00.0 - 10/2014
Foot top feed
⑥
Advertisement
Table of Contents
