Draining The Water-Oil Mixture - DURKOPP ADLER M-Type Delta D867 Operating Instructions Manual

144
Fig. 65: Setting the operating pressure
①
(1) - Pressure controller
To set the operating pressure:
1. Pull the pressure controller (1) up.
2. Turn the pressure controller until the pressure gage (2)
indicates the proper setting:
• Increase pressure = turn clockwise
• Reduce pressure = turn counterclockwise
3. Push the pressure controller (1) down.
6.3.2

Draining the water-oil mixture

NOTICE
Property damage from excess liquid!
Too much liquid can result in damage to the machine.
Drain liquid as required.
The water separator (2) of the pressure controller will show
accumulation of a water-oil mixture.
Proper setting
The water-oil mixture must not rise up to the level of the filter
element (1).
Check the level of the water-oil mixture in the collection tray (2).
Operating Instructions M-TYPE DELTA - 01.0 - 08/2019
②
(2) - Pressure gage
Maintenance