Setting The Rocker Bolt - DURKOPP ADLER 610 Service Instructions Manual

9.1.4 Setting the rocker bolt

Fig. 30: Setting the rocker bolt
(1) - Gauge
(2) - Rocker bolt
(3) - Face of the lower shaft
Check correct setting
The rocker bolt (2) must be pushed up against the face (3) of the lower
shaft.
Setting steps
1. Remove the grease cap (4).
2. Screw the gauge (1), order no. 0933 000735, onto the needle plate
38
WARNING
Risk of injury
Risk of crushing from moving parts
Switch off the sewing machine before adjusting the rocker
bolt.
①
③
②
The second fastening screw (5) is accessible from the upper side of the
base plate.
support.
Setting the looper
⑤
(4) - Grease cap
(5) - Screws
Service Instructions 610/630 - 00.0 - 10/2014
④