Table of Contents
Advertisement
Setting the thread take-up disk
Fig. 68: Manual cutting test
2) Manual cutting test
1. First loosely secure the movable blade (2) with the screw (5).
2. Align the point (6) of the movable blade with the notch (7) of the stationary
3. Tighten the screw (5).
4. Perform cutting test with thread.
Important
If the cut is not clean, check the blade for sharpness or replace with a new
sharp blade.
5. Set the movable blade (2) in cutting position by gently turning in the
Important
A smooth blade movement must be guaranteed.
6. If required, align the stationary blade (1) to the movable blade (2) using
Service Instructions 610/630 - 00.0 - 10/2014
①
(1) - Blade
(2) - Movable blade
(3) - Pressure screw
(4) - Pressure screw
blade (1).
The point should be approx. 0.5 - 1.0 mm away from the notch.
pressure screw (3).
the pressure screw (4).
③
④
②
(5) - Screw
(6) - Point of the movable blade
(7) - Notch
⑤
①
⑦
⑥
71
Advertisement
Table of Contents
