Removing And Installing The Thread Cutting Device - DURKOPP ADLER 610 Service Instructions Manual

3.6.1 Removing and installing the thread cutting device

Fig. 11: Removing the thread cutting device.
(1) - Screw
(2) - Movable blade
Removing the blade
1. Loosen the screw (1).
2. Pull the movable blade (2) to the left out of the counter blade (4).
3. Loosen the screws (3) and remove the thread cutter upwards.
Installing the blade
Fig. 12: Installing the thread cutting device.
(1) - Screw
(2) - Movable blade
(3) - Screws
1. Position the thread cutter such that the blade holder (4) fits over the ball
2. Insert both screws (3) and tighten.
3. Push the movable blade (2) to the right between the counter blade and
4. Secure the blade to the blade mounting (4) with the screw (1).
20
③
①
④ ⑤
lever (5).
the spring plate.
②
(3) - Screws
(4) - Counter blade
③
①
(4) - Blade mounting
(5) - Ball lever
Service Instructions 610/630 - 00.0 - 10/2014
Work fundamentals
④
②
②