Table of Contents
Advertisement
Setting the thread take-up disk
13 Setting the thread take-up disk
Check correct setting
The thread take-up disk (1) should be 5 mm above the carrier plate (2) for
a machine locked in slot E (top dead center of needle bar).
Faults due to incorrect setting
• Missed stitches
• Thread breakage
Cover
Remove the covers on the base plate ( Section 3.5.4, pg. 13)
Fig. 66: Setting the thread take-up disk
(1) - Thread take-up disk
Setting steps
1. Loosen the screws of the thread take-up disk (1).
2. Insert the locking pin in slot E.
3. Turn the thread take-up disk (1) accordingly.
4. Set the disk tightly and tighten the screws.
Service Instructions 610/630 - 00.0 - 10/2014
WARNING
Risk of injury
Risk of crushing from moving parts
Switch off the sewing machine before setting the thread
take-up disk.
The measurement can be performed using gauge 3.
③
②
①
(2) - Carrier plate
(3) - Gauge
69
Advertisement
Table of Contents
