DURKOPP ADLER 610 Service Instructions Manual page 54

Hide thumbs Also See for 610:

Table of Contents

Fig. 45: Setting the needle bar height

(1) - Needle bar

(2) - Screw

Setting steps

1. Loosen the screw (2).

2. Set the needle bar height such that the lower edge of the needle eye

3. Tighten the screw (2).

Sequence

After setting the needle bar height, make the following settings:

• Looping stroke position and looper gauge ( Section 9.6.1, pg. 50).

4. After definitively aligning the looping stroke position, looper gauge and

①

(3) and the upper edge of the looper eye (4) are at the same level.

Important: Do not turn the needle bar to the side while doing this.

needle bar: cancel the lock ( pg. 24).

Setting the looper

②

③

(3) - Lower edge of the needle eye

(4) - Lower edge of the looper eye

Service Instructions 610/630 - 00.0 - 10/2014

④

Table of Contents

630