Table of Contents
Advertisement
16 Setting the tape feed (610)
Fig. 75: Setting the tape feed
(1) - Tape clamp
(2) - Tape guide
Check correct setting
The air flows and speed of the tape guide are coordinated with one anoth-
er:
The tape is fed into the tulle foot (3) at the center, both when viewed from
the front and from the side.
76
①
②
③
• The speed of the feed movement is not too fast.
• The air flow of the tape guide (2) transports the tape faster than the
tape clamp (1) supplies the tape.
• The reverse movement of the tape clamp (1) is not too fast. The tape
does not hang between the tape clamp and the tape guide.
• The air flow is not too strong such that the tape flaps before entry
into the tulle foot (3) and possibly passes it by.
Setting the tape feed (610)
(3) - Tulle foot
Service Instructions 610/630 - 00.0 - 10/2014
Advertisement
Table of Contents
