Setting the needle protection
Cover
• Remove the covers on the base plate ( Section 3.5.4, pg. 13)
• Remove the throat plate ( Section 3.5.5, pg. 14)
Fig. 49: Setting the needle protection
(1) - Looper tip
Fig. 50: Setting the needle protection
(1) - Looper tip
(2) - Needle eye
Setting steps
1. Loosen the screw (3).
2. Adjust the height of the needle protection accordingly.
3. Tighten the screw (3).
4. Loosen screws (4).
5. Move the needle protection to the needle point.
6. Tighten the screws (4).
Important: The needle must not be pushed aside any more than is required.
Service Instructions 610/630 - 00.0 - 10/2014
①
②
①
②
(2) - Needle eye
④
③
(3) - Screw
(4) - Screw
57