DURKOPP ADLER 610 Service Instructions Manual page 50

Hide thumbs Also See for 610:

Table of Contents

Faults due to incorrect setting

• Damage to the looper

• Damage to the needle

• Missed stitches

• Thread breakage

Cover

• Remove the covers on the base plate ( Section 3.5.4, pg. 13)

• Remove the throat plate ( Section 3.5.5, pg. 14)

• Remove the feed (2) ( Section 3.5.7, pg. 16).

• Remove the thread cutter (1) ( Section 3.6.1, pg. 20).

Fig. 40: Setting the looper in the looper mounting

(1) - Thread cutter

(2) - Feed

Setting steps

1. Loosen the screw (4).

Fig. 41: Looper and looper mounting

(4) - Screw

2. Place the gauge (3), order no. 0171 290010, on the right side of the

3. Move the looper (5) to the gauge and tighten the screw (4).

①

②

④

base plate cutout.

Setting the looper

(3) - Gauge

⑤

(5) - Looper

Service Instructions 610/630 - 00.0 - 10/2014

③

Table of Contents

630