Setting The Angle Of Incline And The Height Of The Feeds - DURKOPP ADLER 610 Service Instructions Manual

11.3 Setting the angle of incline and the height of the feeds

Check correct setting
The main feed (right feed mounting - 3) is in the highest position 1.1 mm
and parallel above the surface of the throat plate.
The differential feed (left feed mounting - 2) is in the highest position
1.5 mm and parallel above the surface of the throat plate.
Faults due to incorrect setting
• Damage to the looper
• Damage to the needle
Fig. 53: Height of the feeds
(1) - Screw
(2) - Left feed mounting
Setting steps
1. Loosen the screws (1) and (4).
2. Setting the height of the feed mounting:
3. Tighten the screws (1) and (4).
60
WARNING
Risk of injury
Risk of crushing from moving parts
Switch off the sewing machine before setting the angle of
incline and the height of the feeds.
①
②
• Main feed (3): 1.1 mm
• Differential feed (2): 1.5 mm
Differential top and bottom feed
④
③
(3) - Right feed mounting
(4) - Screw
Service Instructions 610/630 - 00.0 - 10/2014