6. INSTALLATION
• Use the GOT in the environment that satisfies the general specifications described in this manual.
Do not expose the GOT to dust, lamp soot, conductive dust, corrosive gas, or combustible gas; high-
temperature, condensing, wind or rain; or to vibrations and impact.
Failure to do so can cause an electric shock, fire, malfunction or product damage or deterioration.
• Do not drop chips or wire scraps near the ventilation window of the GOT when processing screw holes
or wiring.
Failure to do so can cause a fire, failure or malfunction.
• Tighten the mounting screws within the specified torque range.
Undertightening can cause the GOT to drop, short circuit or malfunction.
Overtightening can cause a drop, short-circuit or malfunction due to the damage of the screws or the
unit.
• Make sure to install the connection cable to the connector specified during the power OFF.
Failure to do so may cause a malfunction due to the poor contact.
6.1 Control Panel Inside Dimensions for Mounting GOT
Mount the GOT onto the control panel while considering the control panel inside dimensions.
6.2 Panel Cutting Dimensions
Make holes in the panel according to the dimensions list below.
Also, ensure 10mm spaces in upper and lower parts of the panel for mounting fixtures.
6
6.1 Control Panel Inside Dimensions for Mounting GOT
- 1
Applicable cable
Some cables may need to be longer than the specified dimensions when connecting
to the GOT.
Therefore, consider the connector dimensions and bending radius of the cable as
well for installation.
A
CAUTION
* Panel thickness: 2 to 4 mm or less
GOT
A [mm] (inch)
383.5(15.1)
GT1595
(+2(0.08), 0(0))
302(11.89)
GT1585
(+2(0.08), 0(0))
289(11.38)
GT157
(+2(0.08), 0(0))
227(8.94)
GT156
(+2(0.08), 0(0))
B [mm] (inch)
282.5(11.12)
(+2(0.08), 0(0))
228(8.98)
(+2(0.08), 0(0))
200(7.87)
(+2(0.08), 0(0))
176(6.93)
(+2(0.08), 0(0))