Equipments Required For Using Got - Mitsubishi Electric Got 1000 Training Manual

1.6 Equipments required for using GOT

Equipment Name
[1] Personal computer
[2] GT Designer2
[3] USB/Cable
[4] Communication Unit
[5] Connection Cable
The equipment required to connect the GOT to the PLC CPU is shown below.
PC
The Ethernet communication
unit is necessary to connect
via an Ethernet cable.
Writing the screen data to GOT.
Software to create screen data
Cable to connect with the personal computer and GOT *1
Unit to connect the PLC CPU connection cable *1
Cable to connect with the GOT and PLC CPU *2
*1 The communication unit varies depending on the PLC connection type.
When connecting to the PLC with the RS-232 port built-in on GOT (direct CPU connection,
computer link connection, etc.), the communication unit is not required.
*2 The connection cable varies depending on the connection type.
The connection cables used for each connection type are shown below.
Connection Type
Bus Connection
Direct CPU Connection
For RS-232 Connection
For RS-422 Connection
Computer Link Connection
For RS-232 Connection
For RS-422 Connection
CC-Link Connection
MELSECNET/10 Connection
For Optical Fiber Cable Connection
For Coaxial Cable Connection
Ethernet Connection
*1 The connection cables are exclusive products.
(Only the Ethernet connection cable is commercially available.)
USB cable,
RS-232 cable
Memory card, Ethernet cable
Screen data transfer
(The illustration shows GT15
Application
Bus Connection Cable
RS-232 Cable
RS-422 Cable
RS-232/422 Conversion Cable
RS-232 Cable
RS-422 Cable
RS-232/422 Conversion Cable
CC-Link Dedicated Cable
Optical Fiber Cable
Coaxial Cable
Ethernet Cable
1 - 9
Connection cable
Connection
PLC CPU
.)
Connection Cable *1