Mitsubishi Electric Got 1000 Training Manual page 11

System Configuration in this Textbook
CPU module
Power supply module
QCPU
(CPU
Q61P-A1
No. 1)
Extension cable
GT15-QC12B
Bus connection unit
GT15-75QBUSL
GT1585-STBA
USB cable
GT09-C20USB-5P
PC
The PLC can also be monitored by
GX Developer or any other relevant
software via direct connection between
the PC and the PLC through an
RS-232 cable.
Output module
Input module
*
QX QY Q64
QCPU
(CPU
42 42P
No. 2)
(64 (64
points) points) points)
X0 Y40
to to
X3F Y7F
Y40
Y60
Y70
Y78
X20 to
X0
to
X8 to
Base unit Q3 B
A multiple CPU version of the Q series training machines is
composed of two CPUs.
Parameters need to be set in GX Developer to enable multiple
CPUs to operate. Set paramters by following the procedures
described below to write to both No. 1 and No. 2 of QCPU.
Q62
<Caution: The following settings are not required unless
AD DA
a multiple CPU system is used.>
(16 (16
<Setting procedure>
points)
1) Doubleclick [PLC parameter] from the project list
in GX Developer.
2) When the Qn (H) parameter setting appears, click the multiple
CPU setting button.
3) Set "the number of CPUs" to "2" in the multiple CPU
setting dialog box.
4) Click the setting completed button.
BCD digital display (four digits x 2)
Y5C
to
Y5F
to
Y5F
Y6F
to
LED x 8
Y77
to
Y77 Y76
LED x 8
to Y7F
Y7F Y7E
BCD digital switch (four digits x 2)
X3F
X7
XF
(7)
I/O panel
Y58 Y54 Y50 Y4C
to to to to
Y5B Y57 Y53 Y4F
BCD digital display
Y6C Y68 Y64 Y60
to to to to
Y6F Y6B Y67 Y63
Y75 Y74 Y73 Y72 Y71 Y70
Y7D Y7C Y7B Y7A Y79 Y78
8 8 8 8 8 8
X3C X38 X34 X30 X2C
to to to to to
X3F X3B X37 X33 X2F
Snap switch (x 8)
X7 X6 X5 X4 X3
Snap switch (x 8)
XF XE XD XC XB
Y48 Y44 Y40
to to to
Y4B Y47 Y43
8 8
X28 X24 X20
to to to
X2B X27 X23
X2 X1 X0
XA X9 X8