4.5.2
Checking that the GOT recognizes the connected equipment
Simultaneous 2-point touch
3)
4)
Check, that the GOT recognizes the connected equipment with the GOT utility.
To avoid problems, always perform checks.
Utility call keys
1)
Power ON the GOT.
2)
When the screen downloaded in section 4.3.3
appears, touch the screen as shown on the
left.
Point
With the GT1595-X, touch the screen as
shown below.
1-point touch at left top corner
3)
When the utility is displayed, touch "Main
Menu" → "Communication Settings".
4)
When "Communication Setting" is displayed,
check that "ChNo1" in Extend I/F Setting is set
to [Q BUS].
4 - 27
Utility call keys