Mitsubishi Electric Got 1000 Training Manual page 68

Point
When the target communication driver is not set, perform one of the following
operations.
(1) Change the communication driver settings
1) Touch the Channel - Driver assign button in the "Communication Settings"
screen.
2) In the "Channel - Driver assign" screen, touch the Change assignment
button.
3) When the communication driver installed in the GOT is displayed, touch
the target communication driver and touch the OK button.
The GOT automatically restarts after this setting is executed.
If project data has been downloaded, the GOT starts monitoring of the
controller after restarting.
Execute this setting after carefully confirming the safety.
(2) Reinstall with the GT Designer2
With the above operation (1), when the target communication driver is not
installed, install it from the GT Designer2.
4 - 28