Mitsubishi Electric Got 1000 Training Manual page 188

F
Falling (trigger)
This is the status when the devices goes from ON to OFF.
With a GOT, the condition established just once at the fall is called a falling trigger.
Be aware that after the device falls, if the time until it comes ON is short, sometimes the fall
cannot be detected and display is not possible.
By setting "initial display", the falling can be forcibly established once even if no trigger is
generated when the screen is switched.
File register (R)
These are extension registers for when data registers (D) are insufficient.
The file register capacity is set with parameters.
The capacity that can be set depends on the CPU used and the memory cassette capacity.
Free location touch switch
Free location touch switches are so called because they are touch switches with a minimum
of 16-by-16 dots (one double-byte character worth), and they can be located freely per dot.
The enabled/disabled area can be specified and the switch can also be protected
conditionally.
G
Graphic operation terminal
The name of the Mitsubishi Electric display unit.
The name GOT is an acronym for Graphic Operation Terminal.
H
Handle
This is the small filled square displayed on the rectangle surrounding a figure when a figure is
selected. Moving the mouse cursor here changes the shape of the cursor.
If the mause is moved with the left mouse button held down, the figure size can be changed.
By holding down
maintaining the aspect ratio.
I
Icon
In Windows, a picture selected (by double-clicking it with the mouse) in order to execute an
application such as GT Designer2
key while the above operation, the figure size can be changed while
Shift
Appendix 34