Connecting Line Input Audio Equipment; Connecting An Audio Multiplexer (Mux) To The Aux In Connector (When Using The Hksr-9001) - Sony SRW-9000PL Operation Manual

To connect a microphone
Mount the microphone in the microphone holder,
connect the microphone cable to the AUDIO IN
CH-1 or CH-2 connector, and set the
corresponding input selection switch to "MIC" or
"MIC+48V".
2
1 Microphone
2 To AUDIO IN CH-1 or CH-2 connector
For details on how to attach a microphone to the
microphone holder, refer to the operation manual for
the microphone.
Notes
• If the input level on this unit is not at an appropriate
setting for the microphone sensitivity, loud sounds
may be distorted, and the signal-to-noise ratio may be
affected.
• The AUDIO IN CH-1 and CH-2 connectors are female
XLR connectors (3-pin), to enable them to provide a
phantom 48 V power supply. If the microphone cable
has a female connector, use a conversion adaptor.
• When you detach the CAC-12 Microphone Holder,
save the screws that you used to attach it and screw
them back into the original screw holes.
Connecting Line Input Audio
Equipment
Connect the audio output connector of the line
input signal source equipment to the AUDIO IN
CH-1 or CH-2 connector, and set the
corresponding input selection switch to "LINE".
1 To AUDIO IN CH-1 or CH-2 connector
2 From audio equipment
1
3 Input selection switches
Connecting an Audio Multiplexer
(MUX) to the AUX IN Connector
(When Using the HKSR-9001)
You can multiplex audio signals into HDSDI
signals and input them to the AUX IN connector
when using the AJA HD10AMA Analog Audio
Embedder/Disembedder, HKSP-105 HD AV
Multiplexer, and HD VTRs such as the SRW-1/
SRPC-1.
Multiplexing into the HDSDI output
signals of this unit
Set REFERENCE on the <GENLOCK> page of
the Camera >MAINTENANCE menu to
INTERNAL or GENLOCK IN.
Connecting Audio Input 35