Table of Contents
Advertisement
Viewfinder screen
Basic status
Message
display (see
page 62)
VDA ROM
MISMATCH
ANOTHER TYPE
OHB
Error Messages Related to the
VTR Module
When the unit stops operating correctly because
of an internal error, a warning tone sounds and a
popup window appears on the display of the
control panel with an error message.
Only one message is displayed at one time, even
if multiple errors occur. But the number of current
errors appears at the bottom of the popup
window.
At the same time, a VTR module error message
appears in the viewfinder and in the message
display section of the monitor screen.
Example:
Popup window displaying error
message "007F HUMID ERROR"
(condensation detected)
There is one current error.
There are two current warnings (see page 190).
To view the other messages, turn the SELECT/
ENTER dial on the control panel.
When an error message appears
Check the message and eliminate the cause of the
error.
Subdisplay
RUN indicator Meaning
If the error involved the tape transport
mechanisms (SLACK-35, etc.), contact a Sony
service representative.
For other errors, power the unit off and on again.
If the same error message appears again when the
unit is powered on, contact a Sony service
representative.
To close the error message popup window
Press the menu selection button "HOME" or
"BACK" on the control panel.
If you press the HOME button, an error code
appears in the operation status and warnings
section of the control panel display (see page 26).
If you press the BACK button, the same error
code appears in the operation status and warnings
section of the display when you move back as far
as the HOME screen.
The error code remains visible until the cause of
the error is eliminated.
Tape protection mode
To protect the tape and the mechanical parts of
the unit, the servo control system automatically
stops tape transport and the drum motor and
enters tape protection mode when an error occurs.
Cassettes may not be inserted or ejected while the
unit is in tape protection mode.
Error messages
Refer to the Maintenance Manual for more detailed
information about the content of error messages, and
about errors not listed here.
Code Message
0010 FAN STOP
0011
0012 ACC POWER
NG
A wrong VDA_PLD version has
written.
Software (ROM data) for the
camera module does not match to
the CCD unit.
Description
A cooling fan stopped.
Error was detected in
current flow monitoring
circuits. Check the
connected accessories.
Warning/Error Messages
189
Advertisement
Table of Contents
