Sony SRW-9000PL Operation Manual page 33

2
Fit the viewfinder to the viewfinder
shoe and slide the viewfinder
horizontally.
The viewfinder stopper slides down
automatically.
Stopper
3
Set the viewfinder to the most
convenient position, tighten the
viewfinder positioning ring (1 in the
figure below), and connect the
viewfinder cable to the VF connector of
the camera (2 in the figure below).
1
2
To detach the viewfinder
Loosen the viewfinder positioning ring, pull on
the viewfinder stopper, then pull out the
viewfinder by sliding it in the direction opposite
that when attaching.
To add a viewfinder shoe
Adding a viewfinder shoe to this unit allows you
to mount the viewfinder in different positions, as
required by the shooting situation.
Before starting, confirm that you have the
following supplied parts on hand.
• Viewfinder shoe assembly
• Viewfinder holding plate (A)
• Viewfinder holding plate (B)
• Conversion screw (1)
• B4×8 screws (2) for viewfinder holding plate
(B) attachment
• M3 hex socket head bolts (2) for viewfinder
shoe attachment
1
Using a Phillips screwdriver, remove
the screws (2) from the right-side face of
the handle.
2
Use the screws that you just removed to
attach viewfinder holding plate (A).
Viewfinder holding plate (A)
3
Using a flat head screwdriver, screw the
conversion screw into the hole at the
front top of the handle.
Conversion screw
Attaching the Viewfinder 33