Connecting Line Input Audio Equipment - Sony HDW-800P Manual

is attached to MIC. Also, set the +48V/OFF
switch to OFF.
• Set the AUDIO IN (CH-1/CH-2/CH-3/CH-
4) switch for the channel to which the audio
output cable is connected to REAR (for
CH-1/CH-2) or R (for CH-3/CH-4).
However, this setting is not needed if the
automatic XLR connection detection
function is ON, because the audio to record
will be detected automatically.
1
1AUDIO IN CH-1/CH-2 switches
2To DC OUT connector
3To AUDIO IN CH1 or CH2 connector
4LINE / AES/EBU / MIC switch
Connecting line input audio
equipment
Connect the audio output connector of the audio
equipment that supplies the line input signal to the
AUDIO IN CH1 or CH2 connector.
Switch settings
Set the LINE / AES/EBU / MIC switch for the
channel to which the audio signal source is
connected to LINE.
Selecting the audio inputs to be recorded
• If the XLR automatic detection function is set to
OFF (factory default), set the AUDIO IN CH-1/
CH-2/CH-3/CH-4 switches for the channels to
which the audio equipment is connected. Set the
switches to REAR (channels 1 and 2) or R
(channels 3 and 4).
• When the XLR connection automatic detection
function is set to on: When a cable is connected
to the AUDIO IN CH1 or CH2 connector, the
input from that connector is automatically
38 Preparing the Audio Input System
4
2 3
selected for audio recording, regardless of the
setting of the AUDIO IN CH-1 or CH-2 switch.
The XLR connection automatic detection
function can be switched on or off on the
AUDIO 1 page of the MAINTENANCE menu,
with the REAR XLR AUTO item.
1
1AUDIO IN CH-1/CH-2 switches
2To AUDIO IN CH1 or CH2 connector
3Audio equipment
4LINE / AES/EBU / MIC switch
4
2 3