Sony SRW-9000PL Operation Manual page 110

To vary the number of frames shot
automatically
Operating mode: Auto (Linear), Auto (Inverse),
or Auto (Even)
1
Turn the ADJUST knob or the
SELECT/ENTER dial to set the Auto
Spd1, Auto Spd2, and Duration items.
Auto Spd1: The number of frames shot of
the ramp start point, or the number of
frames shot of the ramp end point (FPS)
Auto Spd2: The number of frames shot of
the ramp start point, or the number of
frames shot of the ramp end point (FPS)
(This is the end point number of frames
shot when the start point number of
frames shot was set with Auto Spd1.
Otherwise it is the start point number of
frames shot.)
Duration: The time (seconds) from the start
of the ramp to its end.
2
Press the HOME button to return to the
HOME screen.
3
With the FUNC button held down,
press the SELECT/ENTER dial twice.
A screen like the following appears, in which
you can check the settings. (This example
shows the information that appears when the
Auto (Even) mode is selected.)
End number of frames shot
Start number of
frames shot
Operating mode
4
With the FUNC button held down,
press the SELECT/ENTER dial.
The number of frames shot starts to change.
110 Select FPS Function
Duration
Frames recorded
on tape
When the number of frames shot changes to that
of the end point, the values of the ramp start
point and the ramp end point are exchanged.
To stop the number of frames shot
changes
With the FUNC button held down, press the
SELECT/ENTER dial again.
This also causes the values of the ramp start
point and the ramp end point to be exchanged.
To vary the number of frames shot along
a user-specified curve
Note
You will need to prepare a curve file in advance before
carrying out this procedure.
For details on how to create a curve file, see "To
create a curve file" (page 111).
Operating mode: Auto(User)
1
Insert a "Memory Stick" containing a
curve file into the Memory Stick slot.
For details on "Memory Stick" operations, see
"Using a "Memory Stick"" (page 177).
2
Select Load Curve.
A list of curve files saved in the "Memory
Stick" appears.
3
Select a file.
The curve saved in the selected file appears,
allowing you to check it.