Mounting On A Tripod; Attaching The Control Panel - Sony SRW-9000PL Operation Manual

Mounting on a Tripod

Two tripod receptacles (for
are provided on the riser plate at the bottom of the
unit.
3
Tripod receptacles ( / ")
8
Notes
• Select an appropriate hole, considering the balance of
the weight of the unit. If an inappropriate hole is
selected, the unit may fall over.
• Check that the size of the selected hole matches that of
the screw of the tripod. If they do not match, the unit
cannot be attached to the tripod securely.
To use the optional VCT-14 Tripod
Attachment
Remove the riser plate, and use the supplied six
screws to attach the supplied V-shoe plate in the
position indicated in the figure.
V-shoe plate (supplied)
3
/ " camera screws)
8
Mounting on a Tripod / Attaching the Control Panel
Attaching the Control
Panel
The supplied control panel is used for tape and
VTR menu operations. You can attach it to the top
panel of this unit.
1
Place the control panel on the top panel
of this unit, and slide it as shown in the
figure.
2
Connect the cable of the control panel to
the CTRL (VTR) connector, and then
fit the cable into the groove and cable
clamp on the top panel of the unit.
CTRL (VTR)
connector
Align the red mark on the cable plug
with the red mark on the CTRL (VTR)
connector (at the white dot).
Cable clamp
37