Connecting Line Input Audio Equipment; Tripod Mounting - Sony HDW-790P Operation Manual

3
Connect the tuner power cord to the DC OUT
connector of the camcorder, and the audio output cable
to the AUDIO IN CH1 or CH2 connector.
AUDIO IN CH-1/CH-2 switches:
Set the AUDIO IN CH-1 or CH-2
switch for the channel to which
the audio output cable is
connected to REAR.
7-5-4 Connecting Line Input Audio
Equipment
Connect the audio output connector of the audio
equipment that supplies the line input signal to the AUDIO
IN CH1 or CH2 connector.
AUDIO IN CH-1/CH-2 switches:
Set the AUDIO IN CH-1 or CH-2 switch
corresponding to the channel to which the
audio equipment is connected to REAR.
126

Tripod Mounting

Set the LINE / AES/
EBU / MIC switch for
the channel to which
the audio out cable is
attached to MIC, and
set the +48V/OFF
switch to OFF.
to AUDIO IN CH1 or
CH2 connector
to DC OUT connector
Set the LINE / AES/EBU
/ MIC switch for the
channel to which the
audio out cable is
attached to LINE.
Audio equipment
AUDIO IN
CH 1 or CH 2
7-6 Tripod Mounting
You can easily mount and dismount the camcorder on a
tripod by using the VCT-14 tripod adaptor (not supplied).
1
Attach the tripod adaptor to the tripod.
Tripod adaptor
Camera mount
2
Mount the camcorder on the tripod adaptor.
Removing the camcorder from the tripod adaptor
Red button
While pressing the red button against
the lever, move the lever in the direction
indicated by the arrow.
Note
The tripod adaptor pin may remain in the engaged position
even after the camcorder is removed. If this happens, press
Slide the camcorder
forward along the groove in
the adaptor until it clicks.
Lever