Playback - Checking The Recording; Preparing For Playback - Sony SRW-9000PL Operation Manual

Note
When SYSYTEM Setup >SERVO >EOS MODE in
the VTR menu is set to "NORM", the unit plays
about 10 seconds of the recorded portion. If the end
point cannot be found, the unit enters recording
pause mode at that point.
Searching for the end of the last recorded
section and turning on recording pause
mode (EOS SEARCH function)
The EOS SEARCH LONG function allows the
unit to search for the end of a recorded section on
the tape after the recorded section is rewound and
played back.
To use this function, set SYSTEM
>EOS MODE in the VTR menu to "LONG".
For details on VTR menu operations, see "VTR
Menu Operations" (page 157).
EOS SEARCH function
The current tape position
Tape running direction
Recorded portion
Searching for the end of the
recorded portion and turning
on recording pause mode
Note
If there is an unrecorded section between recorded
sections, the unit may behave as if that section is the end
of the last recorded section.
>SERVO
Setup
Blank portion
Playback – Checking the
Recording
You can view playback video by pressing the
PLAY button. Playback video appears in the
viewfinder, and on monitors connected to the HD
SDI MON1 connector, the HD SDI MON2
connector, the TEST OUT connector, and the HD
SDI OUT A/B connectors (when the HKSR-9001
is installed).
You can also view playback video during
recording review, rewind searches (REW), and
fast-forward searches (F FWD).

Preparing for Playback

To make audio monitor signal settings
The VTR >AUDIO Setup menu (see page 162)
allows you to make various settings related to
audio monitor signals for playback.
The procedures are basically the same as those for
making settings related to audio monitor signals
for recording.
To adjust the level of audio output to the
EARPHONES jack
Turn the LEVEL knob.
To adjust playback audio levels
The PB LEVEL item in the VTR >AUDIO Setup
menu (see page 163) allows you to adjust audio
levels separately for each channel.
Note
Playback audio levels cannot be adjusted during
recording.
The PB LEVEL settings window appears when
you select the PB LEVEL item. The subsequent
procedure is the same as steps 1 to 5 in "To set
recording audio levels" (page 86).
To set the display range of the audio level meters
See page 86.
Playback – Checking the Recording 91