Specifying And Displaying Cursors; Checking The Power Supply Voltage - Sony SRW-9000PL Operation Manual

Specifying and Displaying
Cursors
You can display cursors on the viewfinder and
monitor screens.
Example: Box cursor
Activating/deactivating cursor display on
each output
The <CHAR/MARK MIX> page of the Camera
>USER (OPERATION) menu allows you to
activate and deactivate the display of cursors on
each output.
<CHAR/MARK MIX> page
The display of cursors (CURSOR) is set to OFF
for all outputs when the unit is shipped from the
factory.
Item Function
VF Turn the display of cursors on the
viewfinder on and off.
HD-Y Turn the display of cursors on the
monitor on and off.
MON Turn the display of cursors on the
monitors connected to the HD SDI
MON1 or HD SDI MON2 connector
on and off.
Selecting the type and size of the cursor
The <MARKER SETTING> page allows you to
select the type and size of the cursor.
The cursor will appear on an output if cursor
display for that output has been activated on the
<CHAR/MARK MIX> page.
68 Viewing Settings and Indications in the Viewfinder
<MARKER SETTING> page
Item Function
CURSOR Select the type (BOX/CROSS) of the
cursor to be displayed.
POS1 H/V Set the H (horizontal) position
(–958 to +956) and the V (vertical)
position (–538 to +536) of the center.
SIZE W/H Set the width (from the center to right
or left side) (16 to 1920) and the
height (from the center to top or
bottom) (16 to 1080) of the cursor.
Checking the Power Supply
Voltage
You can check the NEAR END and END
settings, which specify trigger values for low
voltage warnings, on the <BATTERY ALARM>
page of the Camera >USER (OPERATION)
menu.
<BATTERY ALARM> page
Item Indication
BATT TYPE Selects the type of battery to
check.
NEAR END Displays the NEAR END value of
the battery selected with BATT
TYPE.
END Displays the END value of the
battery selected with BATT TYPE.
DCIN TYPE Selects the type of power supply to
check.