Rear Panel - Sony SRW-9000PL Operation Manual

c Subdisplay
Displays the Camera menu and unit settings. If
you are using the optional AP-1 Assistant Panel,
the same information appears in the subdisplay of
the AP-1.
d PAGE button
In subdisplay screens, switches to the next page
or confirms settings.
e MENU SEL (selection)/ENTER dial
In subdisplay and viewfinder screens, confirms
settings. When the Camera menu is displayed in
the subdisplay and viewfinder, turn the dial to
select menu items.
Note
When you turn the dial, stop it at a position where you
feel a click. If you force the dial to stop at a non-click
position, the operating stability of the dial on the AP-1
side may be affected.
f SET button
In subdisplay screens, returns to the previous
page. When this button is held down for one
second or longer, the screen enters settings
modification mode.

Rear Panel

a Battery attachment shoe
Attach a battery or AC adaptor.
For details, see "Connecting a Power Supply" (page
29).
b Tally indicator and ON/OFF switch
When the switch is set to ON, the tally indicator
lights during recording. The indicator flashes
when low voltage or an error is detected. You can
set the switch to OFF to prevent the indicator
from lighting or flashing.
See "Warning System" (page 186)" for more
information about when the tally indicator flashes.
c GENLOCK IN (external sync signal
input) connector (BNC type)
Used for input of an external genlock signal (HD
tri sync).
d TC IN (timecode input) connector
(BNC type)
Connect to the timecode output connector of a
timecode generator, VTR, or other external
device. Use this connector when you want to lock
the internal timecode generator to external
timecode.
e TC OUT (timecode output) connector
(BNC type)
Connect to the timecode input connector of a
timecode reader, VTR, or other external device.
The output signal depends on the setting of TC
Setup >OTHERS (MAIN) >TC OUT in the VTR
menu (see page 160).
f TEST OUT connector (BNC type)
Outputs an analog signal selected in the Camera
menu (see page 58).
g DC OUT (DC power output) connector
(4-pin, male)
Supplies 12 V DC power. You can connect the
power cord of the WRR-861 UHF Synthesized
Tuner Unit to this connector.
h DC IN 11-17V (DC power input)
connector (4-pin)
Connect the DC power cord of an AC-DN2B/
DN10 AC Adaptor.
For details, see "Connecting a Power Supply" (page
29).
i AUDIO IN (audio input) CH-1/CH-2
connectors (XLR type 3-pin, female
type) and input selection switches
Input audio signals to the CH-1 and CH-2
connectors.
Locations and Functions of Parts 19