Connecting Line Input Audio Equipment - Sony PDW-850 Operation Manual

attached, and tighten the adjustment
screws to fix its position.
4 Attach the mount plate supplied with
the WRR-862.
About the WRR tuner fitting (service part
number: A-8278-057-B), contact a Sony service
or sales representative.
Adjustment
screws
2
Attach the battery pack.
On how to attach the battery pack, see "To
attach the battery pack" (page 33).
3
Mount the tuner on the WRR tuner
fitting.
4
Connect the tuner power cord to the DC
OUT connector of the camcorder, and
the audio output cable to the AUDIO IN
CH1 or CH2 connector.
5
Set the switches as follows.
• Set the LINE / AES/EBU / MIC selector for
the channel to which the audio output cable
is attached to MIC.
• Set the AUDIO IN (CH-1/CH-2/CH-3/CH-
4) switch for the channel to which the audio
output cable is connected to REAR (for
CH-1/CH-2) or R (for CH-3/CH-4).
46 Preparing the Audio Input System
BP-L80S/FL75
Mount plate
(supplied with
WRR-862)
Phillips type
screwdriver
WRR-862
If the XLR connection automatic detection
function is on, the input signal for audio
recording is selected automatically, and
therefore this setting is not required.
1
1 AUDIO IN CH-1/CH-2 switches
2 To DC OUT connector
3 To AUDIO IN CH1 or CH2 connector
4 LINE / AES/EBU /MIC selectors
Connecting line input audio
equipment
Connect the audio output connector of the audio
equipment that supplies the line input signal to the
AUDIO IN CH1 or CH2 connector.
Switch settings
Set the LINE / AES/EBU / MIC selector for the
channel to which the audio signal source is
connected to LINE.
Selecting the audio inputs to be recorded
• With the XLR connection automatic detection
function being off (the factory default setting):
A signal must be selected for audio recording by
setting the AUDIO IN CH-1 or CH-2 switch to
REAR depending on which of the AUDIO IN
CH1 and CH2 connectors is used for connecting
the external audio equipment.
• With the XLR connection automatic detection
function being on: When a cable is connected to
the AUDIO IN CH1 or CH2 connector, the
input from that connector is automatically
selected for audio recording, regardless of the
setting of the AUDIO IN CH-1 or CH-2 switch.
The XLR connection automatic detection
function can be switched on or off on the
4
2 3