Table of Contents
Advertisement
Name
PAUSE button and
indicator
a) E-E mode: A state in which E-E (electric to electric) signals can be monitored. Commonly used to monitor the camera
picture or the input signal before either is recorded.
b) E-E signal: A signal which passes solely through internal circuitry, and not through pathways in which magnetic
conversion takes place, such as magnetic heads and tapes.
Display
When you press the HOME button with the
FUNC button held down, sections 4 to 7 are
replaced by the display shown in section 9.
This manual refers to the screen shown below as
the HOME screen.
Pressed alone
Pauses tape transport. (The
indicator flashes during pause.) To
resume tape transport, press the
button again.
Pressed with FUNC button
Cues up a time data position specified with
FUNC+REC buttons or SYSTEM Setup
>EDIT >IN POINT in the VTR menu and
stops. The specified time data (Mark In data)
is displayed in the format "IN: xx:xx:xx:xx"
in the time data field of the display.
Note
The Mark In data is only temporarily
memorized in the unit's internal memory. It is
erased when you eject the cassette.
Locations and Functions of Parts
25
Advertisement
Table of Contents
