Table of Contents
Advertisement
Name
PLAY button and indicator Starts playback. (The indicator
Pressed alone
lights during playback.) To start
recording, press this button with
the REC button held down.
Pressed with FUNC button
Pressed with tape transport stopped:
Searches for the recording end point and
then stops. When SYSTEM Setup
>SERVO >EOS MODE in the VTR
menu is set to "NORM" (factory default
setting), rewinds for about five seconds
and then plays for about 10 seconds. If
the recording end point is located in that
section, playback stops at that point and
the unit enters recording pause mode. If
the recording end point is not located in
that section, playback continues for
about 10 seconds and then stops. When
SYSTEM Setup >SERVO >EOS MODE
is set to "LONG", the 10-second search
time limit described above does not
apply. Once playback starts, the search
continues until the recording end point is
found.
For details, see "Continuous recording
in other cases" (page 90).
Pressed with recording paused: Plays back
the most recently recorded material, and
then returns to recording pause mode
(recording review). When SYSTEM
Setup >SERVO >REC REVIEW in the
VTR menu is set to "NORM" (factory
default setting), one press of this button
rewinds the tape about three seconds and
then starts playback. You can keep the
PLAY button pressed together with the
FUNC button to rewind the tape as long
as the buttons are held down (up to a
maximum of 10 seconds), and then start
playback. Recording review allows you
to check whether the material was
recorded correctly. When SYSTEM
Setup >SERVO >REC REVIEW is set to
"ALL", one press of this button rewinds
up to the beginning of the most recently
recorded cut and then starts playback.
Note
Recording review is available when recording
is paused after recording at least three
seconds.
Locations and Functions of Parts
23
Advertisement
Table of Contents
