Connecting Line Input Audio Equipment - Sony HDW-650 Operation Manual

BP-GL65/GL95/L60S/L80S
Adjustment
screws
2
Attach the battery pack.
On how to attach the battery pack, see "To
attach the battery pack" on page 28.
3
Mount the tuner on the WRR tuner
fitting.
4
Connect the tuner power cord to the DC
OUT connector of the camcorder, and
the audio output cable to the AUDIO IN
CH1 or CH2 connector.
5
Set the switches as follows.
• Set the LINE / AES/EBU / MIC switch for
the channel to which the audio output cable
is attached to MIC. Also, set the +48V/OFF
switch to OFF.
• Set the AUDIO IN (CH-1/CH-2/CH-3/CH-
4) switch for the channel to which the audio
output cable is connected to REAR (for
CH-1/CH-2) or R (for CH-3/CH-4).
However, this setting is not needed if the
automatic XLR connection detection function is
ON, because the audio to record will be detected
automatically.
Mount plate
(supplied with
WRR-862)
Phillips type
screwdriver
WRR-862
1
1AUDIO IN CH-1/CH-2 switches
2To DC OUT connector
3To AUDIO IN CH1 or CH2 connector
4LINE / AES/EBU / MIC switch
Connecting line input audio
equipment
Connect the audio output connector of the audio
equipment that supplies the line input signal to the
AUDIO IN CH1 or CH2 connector.
Switch settings
Set the LINE / AES/EBU / MIC switch for the
channel to which the audio signal source is
connected to LINE.
Selecting the audio inputs to be recorded
• If the XLR automatic detection function is set to
OFF (factory default), set the AUDIO IN CH-1/
CH-2/CH-3/CH-4 switches for the channels to
which the audio equipment is connected. Set the
switches to REAR (channels 1 and 2) or R
(channels 3 and 4).
• When the XLR connection automatic detection
function is set to on: When a cable is connected
to the AUDIO IN CH1 or CH2 connector, the
input from that connector is automatically
selected for audio recording, regardless of the
setting of the AUDIO IN CH-1 or CH-2 switch.
The XLR connection automatic detection
function can be switched on or off on the
AUDIO 1 page of the MAINTENANCE menu,
with the REAR XLR AUTO item.
Preparing the Audio Input System
4
2 3
39