Control Panel - Sony SRW-9000PL Operation Manual

f EJECT button
Pressing this button opens the lid of the cassette
insertion slot, allowing you to take out the
inserted cassette.

Control Panel

The control panel is used mainly for control of the
VTR module.
a VTR menu selection buttons
Select one of the VTR menus or the Camera menu
to be shown on the display.
HOME button: Displays the HOME screen. The
HOME screen displays audio levels,
operating status, warnings, time data, and
other information.
TC button: Displays the TC (timecode) Setup
menu (see page 159). This menu allows you
to switch between LTC and VITC, to switch
between DF and NDF, and to display
timecode on an external monitor.
VIDEO button: Displays the VIDEO Setup
menu. The menu allows you to perform
Camera menu operations (see page 115).
AUDIO button: Displays the AUDIO Setup
menu (see page 162). This menu allows you
to make settings related to audio.
SYSTEM button: Displays the SYSTEM Setup
menu (see page 164). This menu allows you
to make settings related to the entire system,
such as recording format, power, and test
signal output.
For details on VTR menus, see "VTR Menu List"
(page 159).
b Display
Displays VTR menus, audio levels, warnings,
operating status, time data, remaining tape time,
and remaining battery power.
For details, see "Display" (page 25).
You can rotate the display to display it vertically
(rotated 90 degrees to the left).
To change the display, press the HOME button
while holding the FUNC and BACK buttons
down.
To return the display to its original orientation,
press the HOME button again while holding the
FUNC and BACK buttons down.
c KEY INHI (inhibit) switch
When the KEY INHI item (see page 167) in the
SYSTEM Setup menu is set to ALL, setting this
switch to ON disables operation buttons, to
prevent misoperations due to accidental button
operations.
ON: All operation buttons are disabled.
OFF: During recording, only the STOP button
and PAUSE button are enabled. All buttons
are enabled when the unit is not in recording
mode.
When the KEY INHI item in the SYSTEM Setup
menu is set to MAP, the operation buttons follow
the settings of the LOCAL KEYMAP item.
d LIGHT switch
The backlight comes on when this is set to ON.
e ADJUST knob
Use to adjust audio levels, etc.
f SELECT/ENTER dial
When a menu is displayed, you can turn this dial
to move the cursor, and press it to select and
confirm settings.
g BACK button
When a menu is displayed, you can press this
button to back up one level in the menu structure.
Locations and Functions of Parts 21