Warning Messages Related To The Vtr Module - Sony SRW-9000PL Operation Manual

Code Message
0013 DC OVERLOAD Current of 10 A or
0014 DC VOLTAGE
DOWN
0015 BATTERY
TEMPERATURE
NG
0050 NO REC RF
0057 EQ NVRAM
SUM ERROR
0058 CONT REC NG
TC
005A CONT REC NG
SV
005C TIMER REC NG Timer Rec error was
005F EQ TEMP NG
0060 SLACK-10
0061 SLACK-11
0062 SLACK-12
0063 SLACK-35
0064 SLACK-45
0065 SLACK-75
0066 SLACK-70
0067 SLACK-71
190 Warning/Error Messages
Description
higher is being supplied
to the DC IN 11-17V
connector or the battery
terminal. Stop the
power supply to
accessories.
Decline in power
supply voltage was
detected.
The internal
temperature of the Info
Battery (battery with a
communication
function such as BP-
GL95) is over the rated
value.
Recording error
occurred. Could not
detect RF signal.
EQ NVRAM operating
error was detected.
Continuous recording
error was detected.
Continuous recording
error was detected.
detected.
Abnormal EQ
temperature was
detected.
Drum drive voltage
error was detected.
Drum FG error was
detected.
Drum PG error was
detected.
S reel rotation was
detected in stop mode.
Abnormal ratio of T
reel speed to capstan
speed was detected
during fast forward.
It is necessary to check
the cassette.
Servo NVRAM
communications error
was detected.
System control
initialization command
error was detected.
Code Message
0068 SLACK-20
0069 SLACK-21
006B SLACK-23
006C SLACK-24
006D SLACK-100
0071 SLACK-61
0072 SLACK-62
0073 SLACK-63
0074 SLACK-64
0075 SLACK-65
0076 SLACK-66
0077 F-TOP SENSOR
ERR
0078 SLACK-32
0079 SLACK-42
007A SLACK-33
007C SLACK-34
007D SLACK-44
007F HUMID ERROR Condensation detector
02XX (An error
message related
to the camera
module)
Warning Messages Related to the
VTR Module
If one of the conditions described in the table of
warning messages (see page 191) is detected, a
Description
Capstan drive voltage
error was detected.
Capstan FG error was
detected.
Capstan rotation
direction error was
detected.
Capstan speed error was
detected.
Tension error was
detected during rewind.
Function cam forward
rotation time-out error
was detected.
Function cam reverse
rotation time-out error
was detected.
Tape top detection time-
out error was detected.
Full top detection time-
out error was detected.
Tape end detection
time-out error was
detected.
Cassette ejection error
was detected.
FULL TOP sensor error
was detected.
(Exchange the sensor.)
S-reel FG error was
detected.
T-reel FG error was
detected.
S-reel direction error
was detected.
S-reel speed error was
detected.
T-reel speed error was
detected.
detected condensation.
An error was detected
in the camera module
(see page 188).