Beep - C-more micro EA1-S6ML Hardware User Manual

Chapter 5: System Setup Screens
Setting – Beep
1 LCD Contrast
2 Backlight

3 Beep

4 Calibration
5 Clear User Memory
6 Reset to Factory Defau t
5
Note: Loading a project to the panel will override whatever selection is choosen for the beeper from the
System Setup Screens' Beep on/off selection screen. The Beep on/off choice can be changed through the
System Setup Screens after a project is loaded.
Note: When the panel is powered through Port1 from a connected PLC or PC, the beep will not function
properly because the panel is running in Low-power mode. To use the beep signal, power the panel from an
external 12-24 VDC power source.
5–10
BAK
SETTING
NXT
>
>
>
UP
>
DWN
ENT
ENT
® EA1-MG6-USER-M Hardware User Manual, 1st Ed. Rev C, 09/10
With Beep
highlighted, press
ENT [F5] to show
the current value for
the internal beeper.
The default is ON.
The UP [F3] and
DWN [F4] function
keys can be used to
toggle between the
ON and OFF state
for the beeper
(enable or disable).
Use the APL [F5]
function key to
apply the selection.
BAK
BEEP
Current Value
on
UP
DWN
ENT
APL