Chemical Compatibility - C-more micro EA1-S6ML Hardware User Manual

Chemical Compatibility

The C-more Micro-Graphic panels are built of three different materials that may be exposed to
elements outside of the enclosure. The panel's screen has a polyester (PET) surface. The bezel
uses ABS plastic materials and the panel's gasket is a silicone rubber material. The following
tables are provided to make you aware of the general compatibility between chemicals that may
be present in your work environment and the various materials used in the manufacture of the
panel. Use the table to determine those chemicals that are safe to use around your C-more
Micro-Graphic panel and those that may harm it. The tables are made up of specifications
provided by the manufacturer of the listed material. The tables rate these chemicals as either
Excellent, Good, Not Recommended, or Not Usable. Because the ratings are for ideal
conditions at room temperature, consider all factors when evaluating your application. Areas left
blank have not been tested by the manufacturer and therefore information of compatibility is
not available.
Screen Sheet – PC
Chemicals
Temperature °C]
Acetaldehyde
Acetic Acid
Acetic anhydride
Acetone
Acetophenone
Acetylene
Acrylonitrile
Alcohol - Butyl Ether
Alcohol - Ethanol
Alcohol - Isopropyl
Alums NH3, Cr, K
Aluminum acetate
Aluminum bromide
Aluminum chloride
Aluminum nitrate
Aluminum sulfate
Ammonia [anhydrous]
Ammonia gas [cold]
Table continued at top of next page.
®
Bezel – ABS
[Density %, [Density %,
Temperature °C]
Not Recommended
[10, 20 °C] Excellent
[10, 20 °C] Excellent
[50, 20 °C] Not Usable
[50-70, 20 °C] Not Usable
[100, 20 °C] Not Usable
Not Recommended
Not Usable
Not Recommended
EA1-MG6-USER-M Hardware User Manual, 1st Ed. Rev C, 09/10
Gasket – Silicone
[Density %,
Temperature °C]
Not Usable
Not Usable
Excellent
Excellent
Excellent
Excellent
Excellent
Excellent
Good
Good
Excellent
Excellent
Good
Good
Chapter 2: Specifications
Bezel Key Sheet –
PET
[Density %,
Temperature °C]
Excellent
2
2–7