Table of Contents
Advertisement
7.2
PROGRAMMING PRESHOTS, CONTINUED
5. Perform one of the following.
6. Program another PreShot by repeating step 1 and steps 3 – 5, or press ESC to
end programming.
7.3
PROGRAMMING VECTORSCANS
VectorScans are one or more PreShots, from the same unit, grouped together and
saved with a number and title. The speed at which the scan travels to each PreShot
and the amount of time the scan remains at each PreShot can be programmed and
saved in the VectorScan. A total of ten (0-9) VectorScans are programmable per
scan unit. Each VectorScan File can contain a maximum of 64 PreShots.
Perform the following procedure to program and store a VectorScan
(in the control camera displayed on the programming controller):
1. Press SHIFT + F6.
2. Type the VectorScan number and press Enter.
3. Type the title of the VectorScan (up to 24 characters) and press Enter.
4. Type the first PreShot Number in the
PreShot Column in the 0 row.
NOTE: After entering data in a field, the
Rev. D
a. Press C to change the location of the PreShot title.
Use the gray up and down arrow keys until the PreShot title is
positioned in the desired location on the screen, then press Enter.
b. Press E to change the title prior to saving the PreShot coordinates.
Once the title is changed, press Enter and follow step c to save.
c. Press S to save the PreShot number, title, and camera scene displayed
on the monitor. Go to step 6.
d. Press D to delete the PreShot. Go to step 6.
e. Press N to save only the title of the PreShot (coordinates are not saved).
cursor moves to the next column.
If the cursor does not move, use
the right arrow key to move it.
NUM
PRESHOT VELOCITY DWELL
••
0
••
.
••
.
••
.
••
63
55
•.•
••
•.•
••
•.•
••
•.•
••
•.•
••
KDMU000799
02/6/04
Advertisement
Table of Contents
