7.2
PROGRAMMING PRESHOTS
A PreShot is a predefined scan and lens position (including the pan, tilt, zoom, and
focus settings, and, in some modes, iris settings).
•
A PreShot is saved with a number and title.
•
The operator uses the PreShot number to send the scan unit to the PreShot.
•
The PreShot title can be enabled or disabled.
•
The location of the PreShot title on the monitor display is programmable.
•
If the camera ID is enabled, the letter A for automatic operation appears next to
the camera number display on the monitor whenever the scan has been sent to a
PreShot.
A total of 98 (00-97) PreShot positions are programmable per unit with the PreShots
stored on the receiver board. If an 843216-1011 or 843216-1013 camera is installed,
PreShot 99 is reserved for toggling the NightShot mode on and off. PreShot 98 is
reserved for the camera reset function.
NOTE: PreShots can also be programmed using the PRGM key on the JPD
NOTE: All keystrokes referred to in the following procedure are using the KBD-100A
1. Adjust the pan, tilt, zoom, and focus of the unit until the desired scene is displayed
on the monitor.
2. Press SHIFT + F5 on the keyboard.
3. Type the PreShot Number (0-97) and press Enter.
4. Type the title of the PreShot (up to 24 characters) on the KBD-100A Keyboard
and press Enter. The following commands are displayed
Rev. D
controller. However, a specific title cannot be programmed using the
PRGM key. See the JPD controller manual for programming procedures.
Programming Keyboard.
C to Change
Change the location of the PreShot title on the display
E to Edit
Edit the PreShot title before saving PreShot coordinates
D to Delete
Delete PreShot
S to Save
Save PreShot coordinates and title
N to Save Name
Saves PreShot title only
54
KDMU000799
02/6/04