Table of Contents
Advertisement
3.1
LOWER DOME MODULE INSTALLATION
1. Remove the lens cap from the camera lens.
2. Install the bottom dome. Follow instructions shown for the specific type of mount.
3.1.1
Indoor Dome with Safety Lanyard Installed on Back Can at Factory
1. Attach the safety cable from the back can module to the bottom dome.
2. For installations requiring CE compliance, perform the following step, otherwise,
go to step 3.
3. Align the bottom dome with the back can module or pendant dome and twist to
lock the bottom dome brackets over the mounting posts. For CE compliance,
tighten the lock screw in the bottom dome with the 5/64" hex key until it is snug.
DO NOT OVERTIGHTEN.
Rev. D
SECTION 3:
KD6i LOWER DOME MODULE
CAUTION: Always handle the bottom dome by the flange
around the dome. Do not touch the inside surface of the
dome.
a. Remove the acorn nut on the mounting screw on the bottom dome.
b. Hook the safety cable eyelet over the screw on the bottom dome and
thread the acorn nut onto the screw. Ensure safety cable is positioned
as shown in drawing. Ensure cable is perpendicular to bracket and
parallel to bottom dome trim ring.
a. Locate the bag containing a lock screw and 5/64" hex key (supplied with
the bottom dome).
b. Insert the 2-56 lock screw through the hole in the bottom dome trim ring
and screw it into the bottom dome inner ring.
Refer to
Figure 3
for illustration of installation.
14
KDMU000799
02/6/04
Advertisement
Table of Contents
