Pan And Tilt Options - Honeywell UltraDome KD6i Series User Manual

5.3 CONTROL OPTIONS, CONTINUED
5.3.4

Pan and Tilt Options

Select 4 to set the pan and tilt manual
control options.
1.
2.
3.
If:
Pan reverse is set to ON
Tilt reverse is set to ON
4.
Rev. D
Manual Speed deg/s –
Select 1 to change the manual
pan and tilt speeds, where the
maximum tilt speed is ½ of the
maximum pan speed. Select 1
to toggle through options:
100°/sec, 200°/sec, 400°/sec
Pan Reverse – Select 2 to turn
Pan Reverse ON or OFF.
(See table.)
Tilt Reverse – Select 3 to turn Tilt Reverse ON or OFF.
+2 Degree Tilt Limit –
Select 4 to turn +2 Degree Tilt
Limit ON or OFF. This allows the
KD6i to tilt up 2 degrees above
horizontal.
1 PASS ............................................ ON
2 Auto-Pivot...................................... ON
3 Program Alarms
4 Set Pan and Tilt Options
5 Set Default Function
6 Auto Focus ....................................... Z
7 VectorScan Auto Focus............... OFF
ESC to Exit
PAN AND TILT OPTIONS
1 Manual Speed deg/s......................400
2 Pan Reverse ..................................Off
3 Tilt Reverse ....................................Off
4 +2 Deg Tilt Limit .............................Off
5 Find Home on Startup ....................Off
6 Pan Offset ......................................Off
ESC to Exit
Then:
A left pan command causes the scan to pan right.
A right pan command causes the scan to pan left.
A tilt up command causes the scan to tilt down.
A tilt down command causes the scan to tilt up.
PAN AND TILT OPTIONS
1 Manual Speed deg/s......................400
2 Pan Reverse...................................Off
3 Tilt Reverse ....................................Off
4 +2 Deg Tilt Limit .............................Off
5 Find Home on Startup.....................Off
6 Pan Offset ......................................Off
ESC to Exit
27
CONTROL OPTIONS
KDMU000799
02/6/04