Table of Contents
Advertisement
5.1
MAIN MENU
Upon power-up of an UltraDome KD6i,
the scan displays an initialization screen
and counts down from 15 to 0. The
standard start-up message screen can be
turned ON or OFF from the main menu.
If the start-up screen message is ON, the
following screen is displayed.
NOTE: The protocol line displays the
If the start-up screen message is OFF,
this screen is displayed:
After the countdown, the scan accepts
control commands. Refer to the
controller users' manuals provided with
your controller for operating procedures.
The first time a scan receives control data with its address, the scan finds home then
performs the command. After the scan finds home, it performs all control commands
with its address immediately.
Rev. D
SECTION 5:
SETUP
NOTE:
•
Refer to
Section 6
(programming) when using standard protocol.
Operation and programming when using iPro protocol
is the same as standard protocol.
•
Refer to
Section 8
(programming) when using Maxpro, Pelco P Code,
Pelco D Code, Burle, or VCL control systems.
•
Refer to
Section 10
(programming) when using an American Dynamics
control system.
protocol set by DIP switch S4.
(operation) and
Section 7
(operation) and
Section 9
(operation) and
Section 11
---- UltraDome KD6i ----
Protocol
9600 baud even parity-8 bits
Camera
Honeywell Video Systems
X
20
Standard
FDB-EX48B
519543-1980
Please wait . . . 15
Please wait. . . 8
KDMU000799
02/6/04
Advertisement
Table of Contents
