Table of Contents
Advertisement
2.5
LINER INSTALLATION
The liner installed on the KD6i scan can be removed if it is not required for your
application.
To remove the liner:
1. Turn the ¼-turn latches counterclockwise to release the liner.
2. Slide the liner out of the "U-bend" of the liner mounting bracket.
To reinstall the liner:
1. Insert the edge of the liner into the "U-bend" of the liner mounting bracket.
2. Line up the two ¼-turn latches on the liner with the holes on the liner mounting
bracket.
3. Insert the ¼-turn latches into the holes and turn clockwise to secure the liner to
the mounting bracket.
Rev. D
1/4-Turn
Latch
Liner
Figure 4: Liner Installation
Liner
Mounting Bracket
"U-Bend"
13
KDMU000799
02/6/04
Advertisement
Table of Contents
