Table of Contents
Advertisement
6.8
SECTOR ID
Sector IDs are used to quickly identify specific areas or scenes a Scan assembly is
viewing while an operator is manually controlling the Scan. Each Scan can be
programmed to store up to 16 sectors. The sectors can overlap. The following
diagram shows two Sector IDs:
Whenever an operator positions the Scan assembly to view an area inside Sector 1,
the title (i.e., FRONT GATE) of Sector 1 is added to the video signal.
NOTE: The sector title display must be enabled to view Sector titles.
6.8.1
List Programmed Sectors
A list of the programmed sectors can be viewed for each scan unit.
The list displays the Sector numbers and titles.
Perform the following steps to view the list of programmed Sector IDs
for the control camera displayed on the programming controller.
Rev. D
If the operator positions the Scan where one or more programmed sectors
overlap, the Scan sequences between the sector titles for 1.5 seconds per
sector. The operator looking at the monitor quickly knows the location the
Scan is viewing. The location of the Sector ID title is programmable.
Refer to
Section 5.2.7
1. Press F8.
2. To view the next page of Sectors (if applicable) press F8 again.
An "End of Directory" message is displayed at the end of the list.
To view page 1 again, press F8.
3. When done viewing the list, press ESC.
for positioning Sector ID titles.
51
KDMU000799
02/6/04
Advertisement
Table of Contents
