Table of Contents
Advertisement
10.7 VECTORSCAN (VIDEO TOUR)
Using an American Dynamics controller, nine (1 -9) VectorScans can be
programmed using the setup menu accessed by PreShot 61.
VectorScan 0 is reserved for the American Dynamics Control System.
Refer to
10.7.1 List Programmed VectorScans
No changes or supplemental instructions are required. Refer to
10.7.2 List Contents of a VectorScan
No changes or supplemental instructions are required. Refer to
10.7.3 Run VectorScan
VectorScans 1, 2, and 3 can be run from the controller using PreShots 30, 40, and
50, respectively. To start a VectorScan stored in a scan unit, the scan must be the
control camera on the system controller.
Example: To start VectorScan 2, send a PreShot 40 command
When a scan receives a command to run a VectorScan, the scan goes to the first
PreShot programmed in the VectorScan at maximum velocity (400°/second) for the
programmed dwell time, then goes to the next PreShot in the VectorScan at the
programmed velocity for the specified dwell time, etc. When a VectorScan is running
continuously, the unit goes from the last PreShot to the first PreShot at the
programmed velocity. The amount of time the scan takes to go to each PreShot
depends on the programmed velocity and the distance to the next PreShot's pan and
tilt coordinates. The velocity is programmable between 1° to 400° per second.
If:
VectorScan auto focus is ON
VectorScan auto focus is OFF
Rev. D
CAUTION: Continuous VectorScan operation for
extended periods of time (> 8 hours) is not recommended.
Continuous operation results in increased zoom lens
failure and maintenance expense.
Section 5.6.2
for programming VectorScans.
Then:
If the VectorScan auto focus feature is
ON, the lens auto focuses continuously
throughout the operation of the
VectorScan
The lens focuses to the focus setting
programmed for each PreShot.
74
Section
6.7.1.
Section
6.7.2.
KDMU000799
02/6/04
Advertisement
Table of Contents
